Northwest Dryer & Machinery Co.

ANTI-PLUG RETROFIT
VENEER JET DRYER TUBE
     (Replacement for Coe^TM, Moore, Raute and Babcock)   

                  The square trailing edge
                  guides veneer into the
                  the next set of rolls
                       
                   The beveled leading edges
                   provide the greatest opening
                   for approaching veneer

The ANTI-PLUG Jet Tube is constructed with a heavy 12 ga. face plate
and a 16 ga. or 14 ga. body.

The tube is available in either a HIGH VOLUME (300) hole
arrangement or the standard (180) 1/2" dia. hole.

              OPTIONAL EASY CLEANOUT ENDS

This particular hanger system works with COE^TM M-72  or M-62 (modified) and Moore (modified) dryers.
Just rotating the closure plate as shown allows you to easily clean the tubes from the small end.

Spring Loaded Clean Out End Cap

(200) High Volume M-72 Jet Tubes Ready to Ship to Roseburg - Weed

Unlike other tubes that are welded one side only, and have a tendency to warp in the heat.
We weld both sides for a quality jet tube that will stay straight in your dryer.

Shown below are (50) Raute Jet Tubes (old style) being prepared for shipping.

Note: Our tubes are (1) piece top and (1) piece bottom!

Our Jet Tubes are fabricated by stitch-welding the Top Plate to the Body on both 

sides their entire length; this allows the Tube to withstand the stresses from heating 

and cooling... they just DON'T WARP! Our Lead Time is 3-4 weeks!

[ Home ] [ Dryer Parts ] [ Patchers ] [ Green End ]

Copyright © 2002 Northwest Dryer & Machinery, Inc.
Last modified: August 09, 2008